Where to Buy
Help support Trailspace by making your next purchase through one of the links above.
Here's what other sites are saying:
Yakima's vehicle specific Q Clips give your Q Tower a secure, glove-like, snug as a bugish, peas in a podesque, custom fit to your doorframe. Q-Clips are sold in Pairs. If you you are using 4 Q-Towers, you will need to order 2 boxes of Q-Clips. Ensure the correct fit for your vehicle using this step-by-step Automated Fit Guide FAQ's: Q: What else is needed to complete a basic rack set up? A: You will need two pairs of clips, a set of Q Towers and one pair of crossbars. Check the fit list to see which clips and crossbar length is correct for your vehicle. Q: Will Q Clips work with older towers? A: Q Clips will integrate with Q Towers only. Yakima makes things retro-fittable where possible, but this is a case where it would have limited their ability to design the best system possible. Q: I didn't see a recommended fit for my vehicle in the Fit List. Don't you think one of these clips would be good enough? A: Whoa, there! Even though Yakima has over 110 unique clip shapes, don't think this is some kind of rack buffet. While Yakima is very active in trying to fit all the vehicles that they can, there will be some that they just can't fit. It can be dangerous to attempt a fit that is not recommended. Q: How much can I carry? A: This varies by vehicle, load type and crossbar length. Check the fit list to find out what load types (bikes, skis, boats, etc.) and weight capacity applies to your car. Q: How can I be sure the system is installed correctly? A: There is no substitute for following all instructions. You can download instructions on the main product page. Be sure to perform both the Clip Safety Check and Tower Safety Check afte
Engineered for the human hand, the Native's ergonomic design maximizes cutting ability while minimizing discomfort and fatigue. This model is all about combining performance and comfort. Since the portion of the knife most in contact with the user is the handle, that became key while the model was in initial development on the drawing table. We've created a handle pattern with two separate finger choils. The first choil (where the blade and handle meet) allow positioning the index finger closer to the knife's sharpened edge for control over the cutting surface. Behind the first choil, the second positions the hand farther back on the folder for dexterous cutting while pushing the blade away from you. Bi-Directional Texturing molded into the FRN handle form varying levels of steps minimizing forward or backward sliding. Carved out of the locking lever is a David Boye Dent insuring the lock remains safely engaged even when gripping the handle forcefully. A section of non-sharpened serrations line the blade's spine yield an additional slip resistant point for the thumb. The blade itself is hollow-ground CPM-S30V steel with a weight reducing swedge ground from the spine. A black steel tip-up clip can be placed ambidextrously on both sides of the handle via a barrel-shaped screw that doubles as a lanyard.
- Ramsey Outdoor