Here's what other sites are saying:
Free Shipping. Scarpa Freeride Binding Plate and Heel FEATURES of the Scarpa Freeride Binding Plate and Heel Best suited for freeride telemark skiing Comes standard with 110mm ski brakes Easy in/out Heel elevator for climbing Increased lateral stability Lateral release function Most active NTN binding NTN Mounting Plate & Heel Provides the best downhill performance available Stand height without ski 30mm Symmetrical bindings
The NTN mounting plates (and heel) give skiers the ability to swap one pair of NTN Freeride bindings between two or more pairs of skis in about two minutes. It's an easy way to maintain a quiver at a fraction of the cost. Think simple, savvy and smart. This can only be used on Fall 2011 and Fall 2012 NTN Freeride (black) bindings. This product is NOT to be used on any pre-Fall 2011 (orange) Freeride bindings.
Lots of skis but not a lot of bindings? The Rottefella NTN Freeride Binding Plate and Heel lets you change-up bindings in about 2 minutes. One plate and heel are required for each set of skis in your quiver for ultimate flexibility. Note: This product is NOT to be used on any pre-Fall 2011 (orange) Freeride bindings but continues to work with current Rottefella Freeride NTN bindings.
- Mountain Gear
What can you do in two minutes' You could mow a burrito, straight-line your favorite ski run, or, with the Scarpa Freeride Binding Plate/Heel, you could swap one pair of NTN Freeride bindings between two or more pairs of skis. It's simple, cost-effective, and smart to maintain a quiver for less. Additionally, you beef up your setup a little, because the risers add 10mm of stand height. This model can only be used on fall 2011 and 2012 NTN Freeride (black) bindings, and is not to be used on any pre-Fall 2011 (orange) Freeride bindings.
Rottefella NTN Brake
Rottefella NTN Freedom Ski Brake
Rottefella NTN Mounting Plates
Black Diamond 01 Backcountry Kit
Voile 3-Pin Cable Traverse Riser
G3 Climbing Wires
TwentyTwo Designs Coil Leash
Garmont 7TM Brake